Exposure to Vehicular Traffic - On the job tool box talks

Download the RMA Sign In Sheet. DOC Format
Download the RMA Sign In Sheet. PDF Format

View the full article

Employees exposed to public vehicular traffic must be provided with, and must wear, warning vests or other suitable garments marked with or made of reflectorized or high-visibility material.

Use a designated, trained flag-person along with signs, signals, and barricades when necessary.


View the full article 

###

Cold Weather can still effect your job site. Winter is not over yet.

Download the RMA Sign In Sheet. DOC Format
Download the RMA Sign In Sheet. PDF Format

Prolonged exposure to cold, wet and windy conditions, even when the temperatures are above freezing, can be dangerous. Extreme cold conditions exist when the equivalent (wind) chill temperature is at or below -25° F (-32 °C). Wind chill temperature is a function of the actual temperature and the estimated wind speed. Under windless conditions, air provides an invisible blanket around the skin. As wind speed increases, this layer of heated air is carried away from the body at an accelerated rate resulting in apparent temperatures well below the air temperature.

Read the full article.

###

Foot Protection-On the Job Tool Box Talks

Download the RMA Sign In Sheet. DOC Format
Download the RMA Sign In Sheet. PDF Format

The average person takes approximately 18,000 steps daily and  there's the possibility of a foot injury with each step. 

Construction jobs can be hazardous to your feet--nail punctures are common--walking on uneven ground, over materials and tools,  or slipping on oil, grease, ice, snow, etc. can result in foot  injuries, or sprained ankles -- foot fatigue can develop from prolonged standing on ladders, walking on re-bar, stone, etc. 

Your job is no place for dress, casual, or tennis shoes -- your feet need the protection of a sturdy work shoe,  maintained in  good condition. 

Concrete, cement powder, or any other chemical entering your shoe or boot can damage the tender skin of the ankle and foot very  quickly.  Other foot injuries result from chemicals that soak  through the shoes causing skin irritation or serious injury. 

Construction work is often performed under wet or damp  conditions  --overshoes can help keep your feet dry, warm and protected from chemical contact. 

Be extremely cautious of your feet and toes when working around  heavy equipment, material stockpiles, and while placing or moving heavy loads. 

Most foot injuries are caused by objects falling or rolling onto  the foot -- safety shoes can reduce the injury from these types of  accidents and they are a must for all workers.  In recent years safety shoe construction has become stronger, lighter and more comfortable to  wear than ever before.

 PROMPT FIRST AID FOR MINOR INJURIES CAN PREVENT MAJOR COMPLICATIONS.

This information provided by: Assurance Agency

Electrical Safety - TBT

Download the full article
Download the RMA Sign In Sheet. DOC Format
Download the RMA Sign In Sheet. PDF Format

Electricity is one of the 4 leading causes of death on construction sites, don’t take it for granted. The following information is being provided to highlight the requirements for the use of extension cords, electrical tools, & temporary power

EXTENSION CORDS

Extension cords shall be of the three-wire type and construction grade. Construction grade cords will be marked with one of the following: SJ, SJO, SJT, STO, S, SO, ST or STO.
• All extension cords shall be visually inspected daily. Check the cords as you roll them out and roll them up. Damaged cords are not to be used until repaired properly
• All extension cords and electrical tools shall be included in the quarterly Assured Grounding Program. Cords and tools need to be checked for missing ground pins, cracked insulation, and other damaged. Each cord will be tested for continuity. Cords will be marked with colored electrical tape at the male end of the cord to indicate that the cord has been tested and is good to use. Personal cords and tools need to be included in this program. 1st Qtr.- White; 2nd Qtr. – Green,; 3rd Qtr. – Red; 4th Qtr. – Orange.
• All extension cords shall be on good condition. Cords with damage such as missing ground pins, cuts to the outer insulation, or pulled out strain relief shall not be used (even when a GFCI is used). Repair or replace damaged cords as needed.
• Plastic and metal multi-outlet strips (computer type multi outlets) are not in accordance with electrical regulations and are prohibited from use. "Homemade" metal outlet box extension cords are not in accordance with electrical regulations and are prohibited from use.
• Flat and two wire extension cords are prohibited from use.
• Cords can not be repaired if there are more than 3 repairs per 25 feet of cord or the inner insulation is damaged.

ELECTRICAL TOOLS
• All electrical tools must be equipped with a third wire ground prong electrical cord or be double insulated.
• All electrical tools, including double insulated, shall be visually inspected daily.
• Damaged tools must be taken out of service immediately and tagged or otherwise identified as damaged and in need of repair.

Provided by: Assurance Agency